Gondola Moving- Atlas Holding Bars installation
The Atlas Holding bars come as a part of the Atlas case. It is so to secure the Atlas back panels. The Atlas holding bars installation is to be done on the upright top at the intersection of each bay. It is a great help for reinforcing the complete unit and preventing the Gondola back panels on the shelving movers to come apart with difficult manoeuvres on the uneven floors.
Instructions for Atlas Holding BarTM instructions
For ensuring maximum security, while the specific manoeuvres on the uneven floor, it is highly advisable to use the Atlas holding barsTM. It is a safety fixture that locks the units together. It is included in the 12 Atlas skates cases.
To use the barTM, the following steps are to be followed,
- Locking bar A is to be inserted from the plate’s (B) middle hole.
- It should be ensured that the hook is towards the bottom and towards the top is the wing nut (D).
- On top of the Gondola pole, the plate (B) is to be laid flat.
- In the 1st 4 slots, the sliding bar (C) is to be inserted on top of the pole.
- Ensure the sliding bar (C) went right through the hole (A) and out onto the opposite end.
- Once done, the wing nut (D) is to be tightened on the locking bar (A) for securing the plate on the pole’s top.
- Holding bars are to be fixed before Atlas Skates are positioned, and once Atlas Skates are removed, the holding bars are also meant to be removed or can stay in place for a future move of the same gondola store fixture.